Autoclaved aerated concrete block production process

Autoclaved aerated concrete block is a building material which is cured by high temperature and high pressure steam. Using autoclaved aerated concrete block can greatly shorten construction period and improve technical efficiency.

1. Storage and feeding of raw materials of autoclaved aerated concrete equipment products:

Raw materials are transported by vehicle to processing plants, coal ash (or sand). Lime powder) concentrated in the raw material yard, with fashion into the bin. Transport to silo for use.

2. Raw material treatment of autoclaved aerated concrete equipment products:

The coal ash (or sand. Lime powder) is sent into the ball mill by the conveyor, and the pulverized fly ash (or sand). Lime powder) fly ash is pumped to slurry tank for storage.

3. Ingredients, mixing and pouring of autoclaved aerated concrete equipment products:

Grinding good slurry by mixing tank in order to automatically JiLiangCheng measurement, measurement of automatic proportioning under casting blender mixing fully mixing, through the bubble carding machine down to die, in the pouring of the slurry process RGL blister card to work even in the slurry bubble, plank when pouring cooked molding box made by pouring shuttle buses to the friction wheel transferred to insert bit position, The cage will be prepared for drilling, and then into the rest room for rest.

4. Primary maintenance and cutting of autoclaved aerated concrete equipment products:

After casting, the shell is sent to the original intensive care room with a conveyor chain for rest. After rest, the shell and the body are suspended to the pre-prepared cutting table with a sling. Remove the mold frame. Then cut as required.

5. Autoclaved aerated concrete equipment products out of kettle, finished products:

After the cut body is cut, the body goes into the steam curing chamber for steam curing. After steaming, it is sent to the breaking position by the tractor for breaking. After breaking, it is sent to the palletizing platform by the single-die fixture. In all the production process, the waste will be recycled and cleaned through the waste recycling system, and the stacked blank body will be finished and stacked by the double mold fixture, and the blocks will be packed by the automatic baler, and then transported by the forklift to the finished product placement area for reasonable placement.